Modeling

Prepare model for hardware connection, add blocks to support hardware protocols

Blocks

Analog Input	Measure the voltage of analog input pin
Analog Output	Send analog output signal to DAC0_OUT pin
Digital Read	Read the logical value of digital input pin
Digital Write	Set the logical value of a digital output pin
FXOS8700 6-Axes Sensor	Get measurement of linear acceleration and magnetic field along the X, Y, and Z axes of the FXOS8700 6-Axes chip
I2C Controller Read	Read data from I2C peripheral device or I2C peripheral device register
I2C Controller Write	Write data to I2C peripheral device or I2C peripheral device register
Push Button	Read logical state of Push button
PWM Output	Generate pulse waveform on specified output pin
Quadrature Encoder	Measure rotation of encoder in ticks
Serial Receive	Read data from UART port
Serial Transmit	Send serial data to UART port
TCP Receive	Receive data over TCP/IP network from remote host
TCP Send	Send data over TCP/IP network to remote host
UDP Receive	Receive UDP message from UDP host
UDP Send	Send UDP message to UDP host

Topics

Tune Parameters and Monitor Data in Model Running on Target Hardware
Tune parameters and monitor a model running on your target hardware.
Exchange Ethernet Data by Using UDP Blocks
The use of UDP blocks to exchange data between the development computer and the target hardware via Ethernet communication
Model Configuration Parameters for NXP FRDM-K64F Board
Parameter and configuration options for creating and running applications on the target hardware.
Log Signals on SD Card

Log signals from Simulink^® models on an SD card mounted on the target hardware.
- STEP 1: Prerequisites for Logging Signals
- STEP 2: Enable MAT-File Logging
- STEP 3: Configure Model to Log Signals on SD Card
- STEP 4: Run Model on Target Hardware
- STEP 5: Import MAT-Files into MATLAB
Getting Started with Simulink Coder Support Package for NXP FRDM-K64F Board
This example shows you how to use Simulink® Coder™ Support Package for NXP FRDM-K64F Board to run Simulink model on a FRDM-K64F board.
Code Verification and Validation with External Mode
This example shows you how to use Simulink® Coder™ Support Package for NXP™ FRDM-K64F for code verification and validation using External mode.
Read Temperature from an NXP FXOS8700CQ Sensor Available on NXP FRDM-K64F Hardware
This example shows you how to use Simulink® Coder™ Support Package for NXP™ FRDM-K64F Board to configure and read temperature from an NXP FXOS8700CQ sensor which is a I2C based sensor.
Exchanging Ethernet Data with the FRDM K64F Hardware
This example shows you how to use Simulink Coder Support Package for NXP FRDM-K64F Board to send and receive UDP data.
MAT-file Logging on an SD Card on NXP FRDM-K64F Board
This example shows you how to perform MAT-file logging from a Simulink® model on a Micro SD card mounted on NXP FRDM-K64F board.