PID in ThingSpeak code

3 Ansichten (letzte 30 Tage)
mostafa mousa
mostafa mousa am 23 Jan. 2021
I tried to write pid code in thingspeak app matlab analysis, but I faced some problem. Can anyone help?
sensed_output = thingSpeakRead(readChannelID), control_signal;
setpoint=23;
Kp = 1;
Ki = 1;
Kd = 1;
T= 5000;
double total_error, last_error;
int max_control=100;
int min_control=0
double error = setpoint - sensed_output;
total_error += error;
if total_error >= max_control
total_error = max_control;
elseif total_error <= min_control
total_error = min_control;
else
total_error = total_error;
end
double delta_error = error - last _error;
control_signal = Kp*error + (Ki*T)*total_error + (Kd/T)*delta_error;
if control_signal >= max_control
control_signal = max_control;
elseif control_signal <= min_control
control_signal = min_control;
else
control_signal = control_signal;
end
last_error = error;
analyzedData = control_signal;00
%% Write Data %%
thingSpeakWrite(writeChannelID, analyzedData, 'WriteKey', writeAPIKey);
  1 Kommentar
Image Analyst
Image Analyst am 23 Jan. 2021
Do not use double or int before the lines where you assign values.

Melden Sie sich an, um zu kommentieren.

Antworten (1)

Christopher Stapels
Christopher Stapels am 25 Jan. 2021
I'd suggest you have a look at the MATLAB onramp. Its a two hour introduction to MATLAB fundamentals, I think you would find it really helpful. Once you have that down, I think writing the PID code will be much easier.

Communitys

Weitere Antworten in  ThingSpeak Community

Kategorien

Mehr zu Prepare and Analyze Data finden Sie in Help Center und File Exchange

Produkte

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by