photo

tje_b


Last seen: 2 Monate vor |  Aktiv seit 2022

Followers: 0   Following: 0

Statistik

  • Thankful Level 2

Abzeichen anzeigen

Feeds

Anzeigen nach

Frage


Why can't Matlab save the acceleration data higher than 8.67KSPS
I used the following codes to save my acceleration data from my Teensy4.1 board connected to my Macbook comport. I find out that...

9 Monate vor | 1 Antwort | 0

1

Antwort

Frage


what is wrong with my FFT from a Shaker with accelerometer mounted
I tried to compute the FFT of the data attached to no avail using the FFT code below. The sensor was mounted on a shaker and I a...

11 Monate vor | 1 Antwort | 0

1

Antwort

Frage


accelerometer data shows nothing in FFT
I upload the data and the code but when I run it, nothing show up. the accelerometer was connected to a shaker and sampled at ...

etwa ein Jahr vor | 3 Antworten | 0

3

Antworten

Frage


i tried pulling my data from arduino port but got error. I am a novice
serialPort = 'COM5'; baudrate = 115200; s = serialport(serialPort,baudrate); pause(4); numsamples = 1000; data = zero...

mehr als ein Jahr vor | 1 Antwort | 0

1

Antwort

Frage


FFT of vibration data in real-time
I have transmited my accelerometer data using wifi and Putty. Can I do the FFT of this data in real-time? If yes, some tips p...

fast 2 Jahre vor | 1 Antwort | 0

1

Antwort

Frage


How do I plot the FFT of signal from accelerometer
The Sample rate of the accelerometer from the arduino IDE was 833Hz and I placed the accelerometer on a shaker, The shaker has a...

fast 2 Jahre vor | 2 Antworten | 0

2

Antworten