How to designate color in contour plot with specific values

How do I color the contour plot black for values of a specific number or higher and lower values will be white?

Answer 1

[Adam Danz]

Here's a demo.

1. Produce the contour plot.
2. Set the binaryThreshold variable that defines the border of white/black
3. Redefine the colormap

% Create contour plot
Z = peaks;
[~,c] = contourf(Z);
cb = colorbar(); 

% Set binary threshold to separate the two colors. 
% See c.LevelList for list of contour levels, although you can
% set this value to any value within the range of levels.  
binaryThreshold = 2.0; 

% Determine where the binary threshold is within the current colormap
% All changes to contour plot should be made prior to this.
ax = gca(); 
crng = caxis(ax);  % range of color values (same as min|max of c.LevelList) 
clrmap = ax.Colormap; 
nColor = size(clrmap,1);
binThreshNorm = (binaryThreshold - crng(1)) / (crng(2) - crng(1));
binThreshRow = round(nColor * binThreshNorm); % round() results in approximation

% Change colormap to binary
% White section first to label values less than threshold.
newColormap = [ones(binThreshRow,3); zeros(nColor-binThreshRow, 3)]; 
ax.Colormap = newColormap; 

% Add gray contour line labels
c.LineColor = [.5 .5 .5]; 
c.LineWidth = 2; 

% Add frame to colorbar 
cb.LineWidth = .7; 

Note that since all colormaps have a discrete number of colors, the border between black & white is very closely approximated and will most likely not cause a problem. For example, with a colormap of 256 colors, if the threshold is set to 33% of the color range, the transition would happen between color #84 and #85 which would be rounded to 84. If this poses a problem, you can either slightly reduce or increaes the threshold or you can change round() to ceil() or floor().

[Sreeparna Majee]

Thank you for the solution. It is working when I want a certain percentage of a contour plot to be black or white. But what would be the case if I want for specific values? For ex: I want white for zero values and black for all other values. just the way in data file, no percentage.

Answer 2

[KSSV]

[c,h] = contour()

c has all the points and h has all the repsective levels. Pick your required level and use plot with the color you want.

[Sreeparna Majee]

Please help in how to define this c and h? For ex I want white for zeroes and black for all other values.

[KSSV]

You dont define c, h; this will be the output of the contour function based on your levels.

[Sreeparna Majee]

See I have values in my data plot. I have to assign colors to respective values as told above. How to define that?