- Apply a torque pulse to get it spinning... OR
- Assign damping to one of the Revolute Joints... OR
- Use a motion input to ONE of the gears
Incorrect velocity of gears in Gearbox
3 Ansichten (letzte 30 Tage)
Ältere Kommentare anzeigen
Hi everyone,
So I'm a building a single stage gearbox as depicted in the figure below in Simulink.
Gear 1 (N = 17 teeth) is given a constant torque of 1000 Nm and meshed with gear 2 (53 teeth).
When I run the simulation I get a ridiculously high velocity profile for either gear that keeps increasing as time passes. Should this value not remain constant? What am I missing that could possibly cause this?
Any help is appreciated!
0 Kommentare
Antworten (1)
Steve Miller
am 20 Dez. 2022
The simulation results you have plotted are correct. You are applying a constant torque to both gears. Applying a constant torque to a rotational system with no damping will result in a system that just keeps accelerating (Torque = Inertia* Acceleration). If you want it to settle at a constant speed, you need to do one of the following:
--Steve
0 Kommentare
Siehe auch
Kategorien
Mehr zu Joints and Constraints finden Sie in Help Center und File Exchange
Produkte
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!