bwlabel changing connectivity of image
1 Ansicht (letzte 30 Tage)
Ältere Kommentare anzeigen
I am trying to use BWLabel to label 1 pixel width line segments. These lines are not straight so I am using a connectivity of 8. When I run bwlabel and view the image of the newly labeled skeleton, it actually is changing layout, size and connectivity of the line segments. The input image is a double. I am using Matlab R2009b.
Am I asking bwlabel to be too sensitive? I am using this as part of a larger code that is trying to find the angle of these segments by using the segment endpoints, so maintaining separation is important.
Below is the code I used to generate the two supplied images
% A = image to be labeled.
figure(1), imshow(A)
A2 = bwlabel(A,8);
figure(2), imshow(A2)
0 Kommentare
Akzeptierte Antwort
Image Analyst
am 31 Mai 2012
Your A image is not what you think it is. I'd bet that it is not a logical image, but a gray scale image with most pixels at 255 but some pixels at a much darker value. Do this
imhist(A);
and see what it shows. Do you have only 2 bins at 0 and 1? Or do you have bins at 0, 255, and, say, 20 or some small number?
You can also try this
A = (A == 255); % Convert to logical image with 1 only where A = 255.
and then label and see what you get.
5 Kommentare
Weitere Antworten (1)
Stephen
am 31 Mai 2012
I agree with Image Analyst. Is your image a jpg or has it been compressed? If so, there are little ghosts that lurk as low intensity values on certain pixels. bwlabel uses any value above 0 (or below?) so those sneaky pixels will get marked. Take a look at what a==0 looks like, or type unique(a) to see a list of the unique intensity values.
0 Kommentare
Siehe auch
Kategorien
Mehr zu Image Processing Toolbox finden Sie in Help Center und File Exchange
Produkte
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!