Patrick

Last seen: 15 Tage vor | Aktiv seit 2025

Followers: 0 Following: 0

Beantwortet
Building and Embedding a Reduced Order Model in National Instruments Hardware (cRIO)
Hi Umar, Yifeng, Many thanks for taking the time to answer my question. I have build some initial transfer function, surface ...

etwa 2 Monate vor | 0

Frage

Building and Embedding a Reduced Order Model in National Instruments Hardware (cRIO)
Hi All, I could do with some guidance on a task required on an National Instruments (NI) LEM controller currently under build...

etwa 2 Monate vor | 3 Antworten | 0

Antworten

Frage

Simscape: Constraining Translational Network with Slider Crank Block
Hi, I am building a Simscape digital twin of a twin-cylinder opposed-piston engine. I am unsure if my basic block configuration...

etwa 2 Monate vor | 0 Antworten | 0

Antworten

Frage

PMLSM FOC Control: Chopper Resistor and PWM Control
Hi All, Quick question. I am modelling an FOC PMLSM drive model. I need to add a chopper resistor and switch (ideal semiconduc...

5 Monate vor | 1 Antwort | 0

Antwort

Frage

Resetting a Simscape Slider-Crank Angular Position Signal to a 0 Value with a Trigger Signal.
Hi All, Forgive me if this topic of signal resetting in Simscape has been ask and solved countless times before. However, I am ...

6 Monate vor | 0 Antworten | 0

Antworten

Beantwortet
Simscape PMSM: WYE Connected Capacitor Bank with Resistive Load
Hi, I have modified the Simscape blocks to describe the WYE-Connected capacitor bank with resistive load. The phase waveforms a...

7 Monate vor | 0

Frage

Simscape PMSM: WYE Connected Capacitor Bank with Resistive Load
Hi, I am Simulating a PMSM with a WYE Connected Capacitor Bank (2mH) with Resistive Load (1 Ohms each phase). This is for power...

7 Monate vor | 1 Antwort | 0

Antwort