MathWorks Motor Control Blockset Team

Last seen: etwa ein Monat vor | Aktiv seit 2023

Followers: 0 Following: 0

Statistik

All

Feeds

Beantwortet
PMSM motor cannot start up when using launchpad F28379D + FOC in simulink
Run the example in open-loop control mode to validate the hardware setup and motor. The example has an open loop start-up. Modif...

etwa ein Monat vor | 0

Beantwortet
示例《Sensorless Field-Oriented Control of PMSM Using DC Shunt Current Sensing》中，仿真和代码生成的相移方向是相反的，应如何理解？
Hello, thank you for the question. Your observation is correct. Hardware configuration is for rising edge but simulation plant l...

etwa 2 Monate vor | 0

| akzeptiert

Gesendet

Motor Control Using NXP™ Development Kits
Field-Oriented Control of Permanent Magnet Synchronous Motor Using NXP™ Development kits

3 Monate vor | 13 Downloads |

5.0 / 5

Gesendet

Demos for Motor Control Deployment on Renesas Controllers
PMSM control examples using the Renesas motor control development kits.

7 Monate vor | 9 Downloads |

0.0 / 5

Beantwortet
Sensorless Control with High Frequency Signal Injection at Low Speed
Please refer to the following document page: Initial Position Estimation and Field-Weakening Control of IPMSM Using Pulsating Hi...

9 Monate vor | 0

Beantwortet
How to generate first value for Kp, Ki of PID in current controller
Please refer to the following document page: Estimate Control Gains and Use Utility Functions.

9 Monate vor | 1

Beantwortet
In the BLDC motor block, a non-standard d'q' Transformation is used. Does this affect the values of L_d and L_q?
Thank you for providing your valuable feedback. The factor of π is a typographical error in the documentation and will be correc...

9 Monate vor | 0

Gesendet

Motor Swap of PMSM Using Microchip MCS MCLV-48V-300W
Run any three-phase PMSM using Microchip MCS MCLV-48V-300W Development Board and dsPIC33AK128MC106 MC DIM

9 Monate vor | 3 Downloads |

0.0 / 5

Gesendet

Demos for Motor Control Deployment on Microchip Controllers
PMSM control examples using the Microchip motor control development kit.

fast 2 Jahre vor | 10 Downloads |

0.0 / 5

Beantwortet
TI F28379D Launchpad Serial Communication Failure
In mcb_param_est_host_read, update the COM port in 3 blocks, Host Serial Setup, Host Serial Receive, Host Serial Transmit. You ...

mehr als 2 Jahre vor | 0

| akzeptiert

Beantwortet
I want to make 'Deploying Motor Control Algorithms on Microchip dsPIC, PIC32, and SAM Controllers'. But MPLAB version is different. Could you give me the 3.50 version?
Hi, Please post a query at MPLAB Device Block page to check if it supports 3.50 version.

mehr als 2 Jahre vor | 0