Jogesh Kumar Mukala

MathWorks

Last seen: etwa ein Jahr vor | Aktiv seit 2021

Followers: 0 Following: 0

I am an Associate EDG Engineer at MathWorks. My major responsibilities are to provide the best support in ML, HDL and FPGA related domains at MathWorks. DISCLAIMER: Any advice or opinions here are my own, and in no way reflect that of MathWorks.

Statistik

Abzeichen anzeigen

Feeds

Beantwortet
How to do Bit Error Ratio Vs. Signal-to-Noise Ratio in semilog graph using Simulink?
I understand that you want to observe the output frequency and plot a semilog graph for bit error ratio vs Signal to noise ratio...

etwa 2 Jahre vor | 0

| akzeptiert

Beantwortet
Impulse noise in simulink
I understand that you want to create a Simulink block that can generate a signal containing 3 or 4 impulses. Derivate of the s...

etwa 2 Jahre vor | 0

| akzeptiert

Beantwortet
If no graphics objects are added to or removed from a figure, does findobj always generate the list in the same order?
Hi, If no graphics objects are added to or removed from a figure, the findobj always generates the list in the same order. The ...

mehr als 3 Jahre vor | 0

Beantwortet
How to code this in matlab code.
Hi, Assuming you want to plot both graphs side by side in a same window, you need to go through subplot, plot, grid and legend ...

mehr als 3 Jahre vor | 0

Beantwortet
Concentric Square Matrix with and without a loop
You may refer to the answer here to see if it meets your requirements.

mehr als 3 Jahre vor | 0

Beantwortet
when I run the code, I only get one plot for f. I need to have a plot for p as well. I need to code this part p(x) =f(x0)l0(x) +f(x1)l1(x) +f(x2)l2(x) to make it works
Hi, The lines "n(i,j) = n(i,j) * (x(j) - t(k))" & "d(i,j) = d(i,j) * (t(i) - t(k))" are leading to the error in the code. The n...

mehr als 3 Jahre vor | 0

| akzeptiert

Beantwortet
Why this simple for loop doesn't work?
Hi, Assuming you want to find the mean of squares of consecutive three elements of 'b' array and store in R1405_bar, the issue ...

mehr als 3 Jahre vor | 0

Beantwortet
I want to create the following function bu i get an error
Hi, Assuming you are trying to create a piecewise function g(t), I understand that the problem is with the last three lines of ...

mehr als 3 Jahre vor | 0