photo

Devendra Bhave

MathWorks

Last seen: etwa 2 Monate vor |  Aktiv seit 2020

Followers: 0   Following: 0

I am a Senior Software Engineer at MathWorks. My major responsibilities are Simulink Design Verifier and verification and validation workflows.
DISCLAIMER: Any advice or opinions here are my own, and in no way reflect that of MathWorks.

Statistik

All
  • Personal Best Downloads Level 1
  • First Submission
  • Knowledgeable Level 1
  • First Answer
  • Revival Level 1

Abzeichen anzeigen

Feeds

Anzeigen nach

Beantwortet
Set design verifiers parameters programmatically
Use parameter DVMaxProcessTime to set maximum analysis time. You must save the model before calling sltest.testmanager.createTe...

mehr als 2 Jahre vor | 0

Beantwortet
Facing issue in test generation using simulink test through matlab commands
It is a bit difficult to establish the root cause of the error based on the above information. I suggest you consult MathWorks t...

mehr als 2 Jahre vor | 0

Beantwortet
Loading results from an excel sheet and launching Simulink Design Verifier again to produce a new Simulink Design Verifier Report
Hi Marco, SLDV supports extending existing test cases to achieve 100% coverage. Let's call the set of test cases you authored ...

mehr als 3 Jahre vor | 0

| akzeptiert

Beantwortet
Loading results from an excel sheet and launching Simulink Design Verifier again to produce a new Simulink Design Verifier Report
Hi Marco, I understand your query as follows: You are running SLDV test generation analysis on your model to get 100% coverage...

mehr als 3 Jahre vor | 0

Beantwortet
Can a different initial Stateflow state be set for a test case/harness?
As per my understanding, you are expecting the default transition of Stateflow Chart to enter in your specified state. Adding...

mehr als 3 Jahre vor | 0

Beantwortet
Central bus initialization in testsequence for multiple harnesses
As per my understanding, you are expecting to call custom code before simulating the harness in Simulink Test Manager. Simulink...

mehr als 3 Jahre vor | 0