How to make a waveform and identify the pahse of a signal?
1 Ansicht (letzte 30 Tage)
Ältere Kommentare anzeigen
Hello everyone!
I truly appreciate if someone helps me as I am realy a new MATLAB user. I have a small signal (only two samples)(attached) and I have made the amplitude spectrum and phase but my proffessor said the phase and waveform are wrong. Then, I need to make the waveform and identify the phase in time domain again. I ppreciated your points in advance! My code is below:
clc;
clear all;
close all;
data=xlsread('1');
amp=data(:,2);%us/f
time=data(:,1);%ms
t=time(1:1:end);
am=amp(1:1:end);
l=length(t);
NFFT=l';
S = fft(amp)/NFFT;
P2 = abs(S)*2;
lP2=floor(length(P2));
mS=P2(1:lP2);
freqS=1:lP2;
figure(1)
plot(freqS,P2,'g','LineWidth',2);
ylabel('Amplituse (dB)','FontSize',14);
xlabel('Frequency (Hz)','FontSize',14);
xlim([-inf max(freqS)])
%.........................
PP=phase(S); %Phase Spectrum
figure(2)
plot(freqS,PP,'g'); %Plotting the frequency domain
xlabel('Frequency (Hz)','FontSize',14);
ylabel('Phase','FontSize',14);
%...............
fx=fft(am);
fx(50:350)=0;
X=abs(ifft(fx));
figure(3)
plot(X,'b','Linewidth',2)
xlim([0 100]);
xlabel('Time (ms)','FontSize',14)
ylabel('Amplitude','FontSize',14')
title('Waveform','FontSize',14')
0 Kommentare
Antworten (0)
Siehe auch
Kategorien
Mehr zu Spectral Measurements finden Sie in Help Center und File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!