How get signal name & change its property between Test Harness & test sequence block ?

Hi All,

I have tried below script to get all the signal name at Test harness setup top level but unable to get signal names between Test Harness & test sequence block.

If anyone can help out will be very helpful.

open ABC_Harness1;

ph = get_param('ABC_Harness1','PortHandles');

LineHandles = find_system(gcs,'FindAll','on','Type','line');

set_param(ph.Outport(1),'DataLogging','on');

signalLines = find_system(gcs,'FindAll','on','type','line');

ports = [get_param(signalLines, 'Name') get_param(signalLines, 'Description') ];

disp(ports);

Answer 1

[Akshat Dalal]

Hi Megha,

I understand you have already found the signals in your harness. You should be able to filter the signals based on the destination blocks, the test sequence block in this case. Please refer to the following documentation which should help you in doing this: https://www.mathworks.com/matlabcentral/answers/452859-how-to-obtain-the-source-and-destination-block-names-and-port-numbers-connected-by-a-signal-in-simul