How to enable the signal visualization blocks in the "QPSK Receiver with ADALM-PLUTO Radio" example?
2 Ansichten (letzte 30 Tage)
Ältere Kommentare anzeigen
MathWorks Support Team
am 15 Dez. 2020
Bearbeitet: MathWorks Support Team
am 18 Apr. 2024
I am trying to use the signal visualization blocks found in the following example (QPSK Receiver with ADALM-PLUTO Radio):
However, I can not find a way to activate these signal visualization blocks as the process to do so is not mentioned in the example documentation.
I had noticed that one sentence in the doc says, "To ensure real-time processing, the model is by default set to run in Accelerator mode, and to remove all signal visualization", but when I tried running the model in Normal mode there was no change. How do I activate these blocks?
Akzeptierte Antwort
MathWorks Support Team
am 18 Apr. 2024
Bearbeitet: MathWorks Support Team
am 22 Dez. 2021
In the example model, if you double click on the QPSK receiver block, you will see the spectrum analyzer and constellation diagram blocks (4 blocks in total) as shown below.
Please right-click on each of these blocks and select 'Uncomment'. Uncommenting all these four blocks should show you the visualizations.
0 Kommentare
Weitere Antworten (0)
Siehe auch
Kategorien
Mehr zu RF Component Modeling finden Sie in Help Center und File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!