How to "Monitor and Tune" Simulink Model from MATLAB
15 Ansichten (letzte 30 Tage)
Ältere Kommentare anzeigen
Blake Stevenson
am 15 Nov. 2020
Kommentiert: Blake Stevenson
am 28 Nov. 2020
I have a Simulink model that controls a DC motor's position. The angular position for the motor to rotate to comes from a constant block, which I write to in a Matlab script using set_param. I've seen how set_param('modelName', 'SimulationCommand', 'start') can be used to start a simulation within Simulink, but is there a similar command to run the model [on hardware] in the "Monitor and Tune" mode?
I want to run the model on the hardware connected to my PC (Arduino Mega), but at certain points in the script, I need the motor to move to a different position. Thus, I still need to be able to write to the model using set_param, so I cannot just build and deploy the model to hardware.
Any advice is appreciated.
0 Kommentare
Akzeptierte Antwort
Chaitanya Mallela
am 26 Nov. 2020
You can try out this command for Monitor and Tune mode
set_param(gcs, 'SimulationMode', 'external')
Weitere Antworten (0)
Siehe auch
Kategorien
Mehr zu Modeling finden Sie in Help Center und File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!