How to configure the FMCOMMS5 Transmitter & Receiver block to transmit data through a specific channel?
7 Ansichten (letzte 30 Tage)
Ältere Kommentare anzeigen
Xiaoxiao Liu
am 12 Okt. 2020
Kommentiert: Arash Jafari
am 28 Jun. 2022
Hi, I'm running the model "HW/SW Co-Design QPSK Transmit and Receive Using Analog Devices AD9361/AD9364". The default channel used in FMCOMMS5 block is channel 1 (TX1A_A & RX1A_A), and it works fine with the default value. Now I try to transmit and receive data through channel 2 (TX2A_A & RX2A_A), so I change the parameter "Channel Mapping" in FMCOMMS5 Transmitter & Receiver block into "2", as indicated in the following instruction:
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/377841/image.png)
However, in this case, I cannot receive anything in the diagnostic viewer. What's wrong with the configuration? Is there anything else I need to configure?
0 Kommentare
Akzeptierte Antwort
Lakshmi Bugide
am 15 Okt. 2020
Hi,
By default, the model "HW/SW Co-Design QPSK Transmit and Receive Using Analog Devices AD9361/AD9364" is designed to work with Channel1 of the device. If you want to transmit and recieve with channel 2 , you need to map the Hardware generation Model (HDL_QPSK) interfaces to Channel2 Target Platform interfaces instead of Channel1 interfaces. You have to change the interfaces at Step 1.3 Set target Interface of IP Core Generation Workflow/https://ww2.mathworks.cn/help/supportpkg/xilinxzynqbasedradio/ug/hw-sw-co-design-qpsk-transmit-and-receive-using-analog-devices-ad9361-ad9364.html;jsessionid=b5a8b838ef5b95014eff2f7ae46c#d122e9019.
2 Kommentare
Arash Jafari
am 28 Jun. 2022
Hello Liu,
Please check the UART console of the carrier board during boot up, if the RX digital tune failed!
Kind Regards
Arash
Weitere Antworten (0)
Siehe auch
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!