Different value of von Mises Stress using Matlab
3 Ansichten (letzte 30 Tage)
Ältere Kommentare anzeigen
Hello,
I am using MATLAB to simulate the stress concentration on a part but the result is always different than any other FE analysis tool (ansys or soildworks)
The maximum stress that I got from ansys was 5.739e7 and from solidworks 3.267e7 where as in MATLAB I got the value of max stress of order e4
Am I missing something very basic...???
1 Kommentar
dpb
am 23 Aug. 2020
Bearbeitet: dpb
am 23 Aug. 2020
Well, you've given us exactly nothing from which to guess how you computed anything in MATLAB or why it should compare to anything else.
I'd say if the results between ANSYS and SolidWorks are different by almost a factor of 2X your models there aren't all that close to each other, either.
Antworten (0)
Siehe auch
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!