Buffer size warning in simulink
87 Ansichten (letzte 30 Tage)
Ältere Kommentare anzeigen
Hello,
I am running a search code with using fminearch. The function that fminsearch calls runs simulink to generate a final output where in Simulink I am running a control system simulation (figure below). Now the question is I am getting this warning multiple times, and I am not sure if this affects the final result or not:
Warning: The specified buffer for 'MRFT_2param_optim/Delay' was too small.During simulation, the buffer size was temporarily increased to 2048. In order to generate code, you need to update the buffer size parameter
![](https://www.mathworks.com/matlabcentral/answers/uploaded_files/284323/image.png)
5 Kommentare
ali ebrahim
am 6 Jun. 2023
you need to click the ling of the buffer to see what block have this problem after that you are going to block setting to adjust the sample time to 1
Antworten (1)
Chidvi Modala
am 29 Jan. 2021
The delay block fills up a buffer with samples until it reaches a duration of one time delay specified by the block parameter. Once this is done, it will begin outputting the signal.
If the sample time was very small and the time delay was relatively large, then Simulink may need to re-size the buffer in order to hold one time delay. While Simulink can perform this operation, the generated code must use fixed buffer sizes and cannot perform this without using a bigger buffer
2 Kommentare
Sebastian Gast
am 28 Apr. 2021
Thank you for the explanation.
could you tell how one can increase the buffer before starting the simulation?
Siehe auch
Kategorien
Mehr zu Sources finden Sie in Help Center und File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!