Why do I get an error about a missing target data map file, although I am using XCP external mode?
22 Ansichten (letzte 30 Tage)
Ältere Kommentare anzeigen
MathWorks Support Team
am 13 Feb. 2020
Beantwortet: MathWorks Support Team
am 13 Feb. 2020
I am trying to run my application using XCP-based external mode. However, I see the following error message about a non-existing "model_targ_data_map" file when I try to connect to the target:
>> set_param(modelname, 'SimulationMode', 'external');
>> set_param(modelname, 'SimulationCommand', 'connect');
Could not execute target data map file 'myModel_myTarget_rtw\myModel_targ_data_map' or it does not exist.
Stop the target, delete the myModel executable, rebuild the code, and try again.
Note that execution of external mode requires the build directory to be present
Akzeptierte Antwort
MathWorks Support Team
am 13 Feb. 2020
XCP-based External Mode does not generate a target data map file. Therefore, we suspect that the the default setup of the External Mode transport layer was modified and the current values are incorrect.
Please type from the MATLAB console the following commands:
>> idx = get_param(modelName, 'ExtModeTransport')
>> cs = getActiveConfigSet(modelName)
>> [transport, mexfile, interface] = Simulink.ExtMode.Transports.getExtModeTransport(cs, idx)
In order to run XCP-based External Mode, you should see the following output:
>> [transport, mexfile, interface] = Simulink.ExtMode.Transports.getExtModeTransport(cs, idx)
transport =
'XCP on TCP/IP'
mexfile =
'ext_xcp'
interface =
'Level2 - Open'
0 Kommentare
Weitere Antworten (0)
Siehe auch
Kategorien
Mehr zu Multicore Processor Targets finden Sie in Help Center und File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!