Thermocouple measurement in Simulink Desktop Real-time using National Instrument devices

Hi,

I want to measure temperature using thermocouple . Currently I have NI-9211 module with chasis NI-cDaq-9174 using these I can get temperture in session based interface. Can I use these hardwares in Simulink Desktop real-time to get temperature and perform real time simulation? If not, then which NI device will be needed to take temperature reading using thermocouple.

Thanks a lot.

Answer 1

[Roshni Garnayak]

Simulink supports NI 9211 and NI cDAQ-9174 for versions R2016b and above.

To get a list of National Instruments hardware supported by MATLAB and Simulink, refer to the following link:

https://www.mathworks.com/hardware-support/nidaqmx.html

[Shubham Yadav]

Thanks for reply.

Yes Simulink supports NI 9211 and Ni cDAQ-9174. Can NI 9211 with NI cDAQ-9174 be used in Simulink Desktop Real time envoirenment using Real time Sync block or any other way?

[Danny]

That is correct regarding Real time Sync block, did you manage to select K type thermocouple in the Simulink Anolog Input block in Data Acquisition Toolbox Library? I can only find mV measurement on my NI9212.