How can I send a square wave to the Tektronix AFG 3022B function generator and change its amplitude using a "To Instrument" block in Simulink?

How can I send a square wave to the Tektronix AFG 3022B function generator and change its amplitude using a "To Instrument" block in Simulink?

Answer 1

[MathWorks Support Team]

You can use the following settings in the "To Instrument" block in order to achieve this in Simulink:

1) In the "Hardware Configuration" tab, you can specify the interface or use the object from the MATLAB workspace.

2) In the "Instrument Initialization" tab, select "Execute function" and provide a function (for example: configureInstrument).

3) Create a MATLAB function with one input argument (the VISA object), for example:

function configureInstrument(v)
    fprintf(v, '*RST');
    fprintf(v, 'SOURCE1:FUNCTION SQUARE');
    fprintf(v, 'SOURCE1:FREQUENCY 10E3');
    fprintf(v, 'SOURCE1:VOLTAGE:AMPLITUDE 1.00');
    fprintf(v, 'SOURCE1:VOLTAGE:OFFSET 0.00');
    fprintf(v, 'SOURCE1:PHASE:ADJUST 0DEG');
    fprintf(v, 'OUTPUT1:STATE ON');
end

4) In the "Send" tab set:

a) Command: 'SOURCE1:VOLTAGE:AMPLITUDE ' (with single quotes, the space at the end is important)

b) Output format: ASCII

c) ASCII format string: '%.2f\n'

With this configuration, at every simulation timestep the command sent to the instrument is going to look like this: 'SOURCE1:VOLTAGE:AMPLITUDE 1.94' (for an amplitude of 1.94). The amplitude value corresponds to the value of the signal at the input port of the "To Instrument" block.