how to load graphs on to GUI from other mat file?

As part of my GUI I need to load a two graphs that were generated from the mat file to the axes. I have written the following code but this is yeilding errors.

function pushbutton1_Callback(hObject, eventdata, handles)
X = main_file_Run(handles)   %X= main_file_Run(handles)
set(handles.pushbutton1,'string','Processing...');
pause(0.01);
handles.text5.String = num2str(X(2));
axes(handles.axes1)= @plot_statistics;
m1 =1;
m2=671+m1;
t1=1:1:672;
plot(t1,load1(m1:m2).*(15/60),'DisplayName','Load','LineStyle','--')
hold
plot(t1,temp(1:672),'DisplayName','Total PV Generation')
ylabel('{\it E} in kWh','FontName','Times','FontName','Times','FontSize',12);
xlabel('{\it t} in hours','FontName','Times','FontSize',12);

axes(handles.axes2);
plot(1:1:672,Ev(m1:m2)*100/Evmax,'DisplayName','Ev SOC')
ylabel('SOC in %','FontName','Times','FontSize',12);
xlabel('{\it t} in hours','FontName','Times','FontSize',12);
set(handles.pushbutton1,'string','optimize');

I have attached a matlab file from which i looked to extract data. Any advise is appreciated.

*NOTE : I do not want to disturb the graphs generated by MATFILE except i want to use the data from the matfile and generate two extra graphs onto axes on GUI created.

Thanks in advance.

[Rik]

What was your intention with this line of code?

axes(handles.axes1)= @plot_statistics;

If you want to re-use part of that file, why don't you do just that? The attached function is quite confusing and there seem to be some mat files that are missing.

[chamant swarup]

Thanks for the responce !

I wanted to call the function "plotstatistics"' but later realized that it is not the way and most importantly i do not want the function to run twice !

I have attached the remaining mat files invovlving the optimzation problem.

So here is the gist :When i run the GUI , the mat files return around 20 graphs , which i dont want to interfere with but in my GUI i need to use the same information in those matfiles to load the two additional graphs . .

[Rik]

There is a big difference between a mat file and an m file. One contains data, the other code.

But for you problem: as long as you can generate the graphs, you can extract the data fairly easily with the XData and YData properties of the axes children. Then you can replot the data inside your GUI. If you need to, I could probably write a proof of principle, but I won't be doing so today, nor probably with your data.

[chamant swarup]

intresting i will try it out with the same.

Thanks anyway!