scope output

Hi all, i have a brief question

I want to simulate a voltagesource's output voltage signal for 10second, I get the source,measurement block and scope from the lib and set the simulation step time to 10.Then I check the scope output but I see everything but a sine wave, a very disturbed output.I can't find what I'm doing wrong.

I'll be glad if anyone helps me out. Thanks in advance

[bym]

can you be more specific?

[murat]

i am trying to get a clean 50hz sinewave for 10seconds simulation timr

Answer 1

[Andreas Goser]

Typically, disturbed ouputs in scopes are based on the misunderstanding that a scope can display more data points than are simulated. Please verify your settings with regards to the simulation step size.