When using the FFT tool from the powergui, a whole cycle is not analyzed despite indicating the number of cycles is 1.
1 Ansicht (letzte 30 Tage)
Ältere Kommentare anzeigen
The signal being used as the input to the FFT analysis tool is a filtered inverter signal (filtered by hardware and PWM control). I expect the THD to be much less than 48.34% as this is the THD expected from an unfiltered inverter. If I increase the number of cycles to include more of my waveform, the THD increases.
Any suggestions?
![FFT error.PNG](https://www.mathworks.com/matlabcentral/answers/uploaded_files/215170/FFT%20error.png)
1 Kommentar
Kuluru Sudarsana Reddy
am 18 Mai 2021
I too have encountered the same issue. If anyone can help us to analyze the issue, that would be great
Antworten (1)
Santiago Alfonso Ospina Botero
am 5 Apr. 2023
I beleive that your problem relies in the fundamental frequency that you have introduced (60Hz) when in reality the fundamental frec of your sinusoid is about 9.3 Hz. This would explain why the red line representing 1Cycle chops at around 0.02 s since 1/60 = 0.0167 s.
So I would recomend to change the fundamental frecuency to the actual sinusoid freaquency or increment the number of cycles to have a better representation of your signal for the FFT computation
0 Kommentare
Siehe auch
Kategorien
Mehr zu Spectral Measurements finden Sie in Help Center und File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!