MATLAB Answers


Unable to download noninlined S-function into Arduino-2560

Asked by Raja Rout on 9 Aug 2012
Latest activity Answered by Murat Belge on 10 Apr 2014
Hi, I am using "Simulink Support Package for Arduino Mega 2560 Hardware" and it works perfectly fine. Thanks for the support.
I would like to add a non-inlined sfunction. For this i have chosen the noninlined sfunction button inside configuration->code generation->interface pane, but i am unable to generate the code.
Thanks in advance


Could you please also specify the error message that you receive?
The following error message is generated during code generation
"Block 'untitled2/S-Function' is a non-inlined s-function, which is not supported with the current configuration. Consider selecting the support 'non-inlined s-functions' option on the Configuration Parameters > Code Generation > Interface pane**"

Sign in to comment.

2 Answers

Answer by Rolfe Dlugy-Hegwer on 28 Aug 2012

Try the following: # Press Ctrl+E. # In the Configuration Parameters dialog that opens, select "Code Generation" and then "Interface". # In the Interface pane, select the checkbox next to "non-inlined S-function".

  1 Comment

Hi Rolfe, I have a similar problem, but for the raspberry pi. I've tried using this solution, but it appears to invalidate the raspberry pi code deployment setup, after which the option to run the model in external mode disappears, and a dialog offering to automatically re-setup the code generation parameters for raspberry pi is again presented. If the dialog is accepted, then the non-inlined box is automatically unchecked, and run external is again offered. Is there perhaps a minor modification which I could make to a config file somewhere, to override the raspberry pi model deployment non-inlined s-function check, so as to enable running external on the pi with non-inlined s-functions? Best Regards, Eric

Sign in to comment.

Answer by Murat Belge on 10 Apr 2014

Non-inlined S-functions are not supported by Arduino, Raspberry Pi or LEGO EV3 / NXT support packages. You can only use inlined S-functions with these support packages.


Sign in to comment.