how to open the specific scope

Hi all i have a simulink model which consists of 20 to 30 scopes at diffrent subsystems. i would like to open the specific scopes ( may be 3 to 4 scopes at a time) automatically, once simulation time is completed.

my question is

1. is it possible to open the specific scopes automatically?

thanks to you for spending your valuable time.

Thanks & Regards venkat

[K E]

Just a head's up, a lot of scopes will slow your simulation; see this blog post.

Answer 1

[Azzi Abdelmalek]

assume

 ModelName='fic';     % your simulink model name
 SubsystemName='sub1'  
 ScopeName='scope1'
 % to open this scoppe :
 open_system('fic/sub1/scope1')

 % you can do the same to open any system or subsystemem
 % to close it
 close_system(ModelName)

[Venkatapathi]

Hi Mr.Azzi Abdelmalek

your solution is working...

Thank you very much

venkat

[TAB]

To open the scopes automatically when simulation is completed, add above code in model's StopFcn callback.

[Venkatapathi]

Hi TAB..

iam able to open the scopes automatically by using StopFcn callback..thanks

[Slimeni Omar]

hi

please i would like to know

how to impliment a scope in simulink model with matlab command ,just from the librery browsers

[Rohail Bootwalla]

Did you get an answer?