How to use the Assignment block?
2 Ansichten (letzte 30 Tage)
Ältere Kommentare anzeigen
Hi guys,
I have been trying to replace the blocks used in the right half part of the snip shown below with the Assignment block. But I am not sure of how to use the initialisation input signal(Y0) to this block, as my input and the initialisation in this case seem to be the same.
Thanks in advance for your response.
2 Kommentare
madhan ravi
am 12 Apr. 2019
Bearbeitet: madhan ravi
am 12 Apr. 2019
Which is y0 ? What are you trying to do? More description needed.
Antworten (1)
Mark McBroom
am 15 Apr. 2019
I thing the proper modeling pattern for this case would be an "If Subsystem" connected to two "If-Action" subsystems. If condition is true, one subsystem will be activated which will write to CW port, else other subsystem will write to ACW port. Note that for subsystem that is not active, you can configure it to either hold last value or reset.
0 Kommentare
Siehe auch
Kategorien
Mehr zu Subsystems finden Sie in Help Center und File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!