Data analysis and for loop
1 Ansicht (letzte 30 Tage)
Ältere Kommentare anzeigen
I am trying to create a table where I can get the timestamp at which there was fault and duration for which the fault was active. Below is my code. My code works for 1 faultcode. I have 500 fault codes. So I used a for loop to automate it and basically stuck on this point. Any leads where I can do it for 500 fault codes without inserting a fault code again? Basically what I want is a table Z for every fault code.
%Input the Fault Code
Faultcode = input('Enter the fault code - ');
% Find the Fault Pattern in the data
pattern = [Faultcode, 0];
a = transpose(Value);
idx = strfind(a, [Faultcode,0]);
result1 = reshape([idx; idx + length(pattern) - 1], 1, []);
req1 = TimeUTC(result1);
timestamp = req1(1:2:end);
date=datetime(timestamp,'ConvertFrom','datenum');
% Extract the timestamps of only fault codes where neccessary and add the
% difference
x1=req1;
h1=(x1(2:2:end) - x1(1:2:end)) * 24 * 60;
Z=table(date,h1);
1 Kommentar
dpb
am 20 Mär. 2019
Need a data source that contains the fault codes; read it and then iterate over the list.
Antworten (0)
Siehe auch
Kategorien
Mehr zu Map Display finden Sie in Help Center und File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!