Run transmitter and receiver model in 1 model or 2 separate model in parallel
1 Ansicht (letzte 30 Tage)
Ältere Kommentare anzeigen
Ardeal Liang
am 18 Okt. 2018
Kommentiert: Ardeal Liang
am 25 Okt. 2018
I have only 1 set of the hardware boards(AD-FMCOMMS4-EBZ(which is AD9364) and Zedboard). so I will run both transmitter and receiver on Zedboard.
1) if I run transmitter and receiver in one model in Simulink, I could receive the discontinuous sin wave shown in the following picture.
2) if I run transmitter and receiver in 2 different models in Simulink in parallel, I could not receive any data from receiver. This is really weird. I cannot figure out the reason and difference.
The example models I am using are:
https://ww2.mathworks.cn/help/supportpkg/xilinxzynqbasedradio/examples/frequency-offset-calibration-using-analog-devices-ad9361-ad9364.html
Transmitter model: zynqRadioFrequencyCalibrationTxAD9361AD9364SL
Receiver model: zynqRadioFrequencyCalibrationRxAD9361AD9364SL
*At present my questions are: a) how to receive continuous sin wave from receive?
b) why could I not receive any data from receiver if I run transmitter and receiver separately and in parallel?*
By the way: I am able to use command and Spectrum Analyzer to make sure transmitter is running while I start receiver.
I am suspecting whether there might be some special settings in Model Configuration Parameters
0 Kommentare
Akzeptierte Antwort
Weitere Antworten (0)
Siehe auch
Kategorien
Mehr zu RF Blockset Models for Transceivers finden Sie in Help Center und File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!