Is there a way to stop compiling process when the model has started to compile in Simulink?

I am running Simulink with Raspberry Pi and when I had hit RUN button, I realized that the model had some errors, but couldn't find any option to TERMINATE THE COMPILATION PROCESS

Either I'd have to wait 20 minutes for the compilation process to complete or restart MATLAB.

I had to chose the 2nd one.

[Sameer Gadekar]

Did you find solution for this?

[Charles Collins]

The million dollar question, and all quiet here.

[Michal Semonský]

would this command help?

set_param(gcs, 'SimulationCommand', 'stop')

Answer 1

[Lev Vitkin]

try

eval([bdroot '([],[],[],''term'')'])

[Li Dang]

This works for me, thanks!

Answer 2

[Guy Rouleau]

In MATLAB R2020b and before, there is no way to interrupt the model compilation.

We are aware that this is a common pain point and are working on a solution to address it. It should soon be possible ot interrupt the model compilation.

Thanks,

Guy

[Guy Rouleau]

In the latest version we added a "Cancel" button on the status bar that can interrupt model compilation.

[Sohil Shrestha]

Is there a way to programmatically achieve this?

Basically probe a thread that is compiling to check if it has finished compiling, (if it is not, say taking too long to compile), interupt it and move on.

[Sohil Shrestha]

Compiling it as follows:

Is there a programmatic way to detect and interrupt the compilation?

slreportgen.utils.compileModel(model)
compiles = slreportgen.utils.isModelCompiled(model);
if compiles  
    slreportgen.utils.uncompileModel(model);  
end 

[Matthew]

Did the issue of being able to interrupt the compilation ever get resolved?

[Guy Rouleau]

Since a few releases, a "Cancel" button shows up at the bottom of the model to interrupt model compilation:

[Ghizlane]

i can't see the cancel boutton should i do an update ? and how ? thank you