Remote PTZ camera(Samsung SNP-6201H) from Matlab application Using commands

I have Samsung SNP-6201H PTZ camera and I need to Control(move, zoom......) it using Matlab. are there any commands to control this camera from Matlab application??

[Paolo]

I have worked with an ACTi PTZ camera before and I communicated with the camera using HTTP commands. Is your camera connected to the network? What have you tried so far?

[omar elharrouss]

for video streaming, I use this IP address. but now I need to access to parameters of the camera automatically using Matlab to : -moving the camera to a specific angle. -zooming the camera. I don't know the commands to do this. can you tell me which commands that you use?? Thank you.

[omar elharrouss]

Sorry the URL for streaming is : http://ipadress/cgi-bin/video.cgi?msubmenu=mjpg

[Paolo]

You will need to construct the HTTP command according to your camera. For example, is authentication required?

To communicate with the camera, I had to translate the decimal values of the commands to hexadecimal A command to tilt 20 degrees looked like this:

 http://130.160.183.160/cgi-bin/mpeg4? 
 USER=Admin&PWD=Admin&SERIAL_HEX=01002A00C8E3

A command to pan 20 degrees:

 http://130.160.183.160/cgi-bin/mpeg4? 
 USER=Admin&PWD=Admin&SERIAL_HEX=01002900C8E0

You can then execute the command using webread.