While Saving the figure in pdf format (MATLAB 2010A)it shows an error message saying PSlevel must be 1 or 2. What should i do to have my figure in pdf? And after clicking on Exit debug mode it shows the file with the error on line 206/1063..

[Vishwanath Bailore Acharya]

Can you once try saving the figure using 'hgexport' with just 2 parameters, by removing the style format as follows?

hgexport(hfig, filename);

Please update if you are facing the issue after trying the above command.

Answer 1

[Sujay Kadam]

May be this is too late, but I wonder if the following would help:

clear fig_property
fig_property.PSLevel= '1';
hgexport(gcf,'Plot.pdf',fig_property);