Arduino ReadDigitalPin all ones
1 Ansicht (letzte 30 Tage)
Ältere Kommentare anzeigen
Hi, I'm trying to connect an arduino to matlab to collect data from the digital pins. I am sending data to pin D3, but when I say readDigitalPin(a,'D3') in matlab it just gives me 1. My code is below, any advice would be appreciated.
if true
a = arduino('com8', 'uno');
t1 = 0;
dt=[];
dv=[];
tic
for i =1:500
i;
tic;
v = readDigitalPin(a,'D2');
dT = toc;
t1 = t1 + dT;
dt(i) = [t1];
dv(i) = [v]
pause(0.5)
end
end
1 Kommentar
Walter Roberson
am 4 Mai 2018
Have you put an oscilloscope onto the pin to verify that the value goes lower than the threshold at some point, and does so for longer than the hold time of the sampling hardware?
Is D2 configured as a continual read or is it configured as triggered by edge detection? If triggered then what are the reset conditions?
Antworten (0)
Siehe auch
Kategorien
Mehr zu MATLAB Support Package for Arduino Hardware finden Sie in Help Center und File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!