Updating the Active Power of a Three-Phase Parallel RLC Load during Simulation Run Time
5 Ansichten (letzte 30 Tage)
Ältere Kommentare anzeigen
Hi all,
I have a simulink simulation that runs for 20s. At every 5s, it will perform a new set of calculations and update the variable 'R' in the workspace automatically via the 'assignin' command.
Now I would need to read in this updated variable into the Active Power (under block parameters) of the Three-Phase Parallel RLC Load in my simulink model. May I know if the set_param command is able to perform this function in this situation? Or is it impossible to write into the Active Power of the Three-Phase Parallel RLC Load?
Any help or advice would be greatly appreciated! Thank you!
Best Regards, Rachel
This
Best Regards, Rachel
0 Kommentare
Antworten (1)
Sabin
am 3 Okt. 2023
Probably best to use variable Resistor/inductor/capacitor in this situation. It is then possible to update the value during simulation.
Variable resistor in Simscape technology:
Variable resistor in Specialized Power Systems technology:
0 Kommentare
Siehe auch
Kategorien
Mehr zu Switches and Breakers finden Sie in Help Center und File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!