Unsure why my for loop isnt working
2 Ansichten (letzte 30 Tage)
Ältere Kommentare anzeigen
Hey All
I am unsure why my for loop isnt working
Essentially I have 6 sets of acceleration data, which I have opened and multiplied by a fixed mass to give me 6 sets of force data - labeled ft1,ft2 etc
I would like the loop to go through these 6 sets of forces
I have also interpolated the forces as my time step in the data is too large so I have made it smaller- and so need to interpolate my ft (force) values for the new time step t_interp to get my interpolated force ft_interp.
However when i run the code, I seem to be getting 0 values for my ft_interp.
I am unsure why it isnt running through each force value
Hope you can help!! Thanks in advance!! This is a snapshot of the loop
%fclose('all'); % Close the file Record_X.txt
m=773;% mass of structure in Mg
ft1 = m*acc1.';
ft2= m*acc2.';
ft3 = m*acc3.';
ft4 = m*acc4.';
ft5 = m*acc5.';
ft6 = m*acc6.';
ft7 = m*acc7.';
for ft=[ft1,ft2,ft3,ft4,ft5,ft6]
dt = 0.02; %time step of data (seconds)
NPTS = size(ft,2); %no.of points
tf = (NPTS-1)*dt;
t = 0:dt:tf;
dt_interp=0.005; %interpolating the data time step to increase no. of points
t_interp=dt_interp:dt_interp:tf;
ft_interp=F_interp(t,ft,t_interp); % interpolating the corresponding force values
NPTS_interp=size(t_interp,2);
end
1 Kommentar
Antworten (1)
Bob Thompson
am 7 Mär. 2018
One of the problems you're going to have is in your number of points definition.
NPTS = size(ft,2);
Your for loop looks at all individual values of ft# so ft is always a single value, and NPTS results in 1. Follow that down and you have tf = 0 -> t = 0 -> all results taken at single time.
I'm assuming that you want to look at all values of a single ft# so I would suggest defining NPTS outside of the for loop, or adjusting the index of your for loop.
NPTS = size(ft1,2); % If they are all the same size
NPTS = size(ft{index},2); % If you want to loop through all acceleration files as a whole.
Side note, I would suggest putting all of your acceleration and force data into cell arrays. It makes it much easier to call them in a loop, and can allow you to define functions such as m*acc in a loop instead of individual equations.
2 Kommentare
Bob Thompson
am 7 Mär. 2018
You can name your index whatever you would like, I just wrote out the word so you would understand what I was referring to. The purpose of this particular index though is for the cell array created by combining all of the ft# arrays into one cell array, which I called ft.
Siehe auch
Kategorien
Mehr zu Matrix Indexing finden Sie in Help Center und File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!