Simulation mode "Normal" for protected models?

Hi community,

I've tried to export a model as protected model. That works fine and I can also insert a model block with a link to the protected model file.

However, in the Model block parameters, there are only the simulation modes Accelerator and SIL available, but not Normal mode; does any one know, why? Can it be controlled by settings in the main model or in the protected model? By the way: both the main model and the protected model are set to Normal mode.

Thanks a lot and best regards - Thomas

[Thomas Becker]

Sorry, I've just found the restriction in the online documentation: Use Protected Model in Simulation . Sorry, don't know why I've missed it when reading before...