How to read low amplitudes on a scope in simulink?
1 Ansicht (letzte 30 Tage)
Ältere Kommentare anzeigen
I'm trying to measure the peak-to-peak of the attached signal. But as you can see, all numbers are in the same order of magnitudes.
So is there any way to export these signals to workspace so that I can plot on a figure and use the cursor to see a precise numbers? or is there a solution in simulink itself?
0 Kommentare
Antworten (0)
Siehe auch
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!