Removing a block and making connections

36 Ansichten (letzte 30 Tage)
Michael Joslin
Michael Joslin am 20 Feb. 2012
Kommentiert: Marco Baratelli am 22 Jan. 2016
Lets say I have a simple subsystem that is just an inport, an outport and a gain block. I want to get rid of the gain block and just have the inport connected to the outport. If i use replace_block I can only replace the gain with another block and if I use delete_block it will remove the gain but leave two disconnected lines. How can I remove this block and make the connection between the remaining two using code?

Akzeptierte Antwort

Jarrod Rivituso
Jarrod Rivituso am 20 Feb. 2012
I've run into this before. My solution was to find port handles and reconnect. I'm not sure if there is an easier way.
Here's a function that should do the trick:
function removeAndReconnectBlock(blockHandle)
%Get port handles and parent system
portHandles = get_param(blockHandle,'PortHandles');
sys = get_param(blockHandle,'Parent');
%Get source port
srcSignal = get_param(portHandles.Inport,'Line');
srcPort = get_param(srcSignal,'SrcPortHandle');
%Get destination port
destSignal = get_param(portHandles.Outport,'Line');
destPort = get_param(destSignal,'DstPortHandle');
%Remove
delete_line(destSignal);
delete_line(srcSignal);
delete_block(blockHandle);
%Reconnect
add_line(sys,srcPort,destPort)
Note that this only works for single input, single output blocks, but I'm sure you could see how you would extend it further.

Weitere Antworten (1)

chandu
chandu am 8 Dez. 2014
May I know how to disconnect SimPowerSystems blocks using PortHandles? Please help me ASAP.....
  1 Kommentar
Marco Baratelli
Marco Baratelli am 22 Jan. 2016
The following works for me using SimScape! Hope it helps.
sbh = getSimulinkBlockHandle([sys '/NameOfYourSpecificBlock']);
ph = get_param(sbh,'PortHandles');
srcSignal = get_param(ph.RConn,'Line'); % or LConn for left connection of the block
delete_line(srcSignal);

Melden Sie sich an, um zu kommentieren.

Kategorien

Mehr zu Programmatic Model Editing finden Sie in Help Center und File Exchange

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by