MATLAB Answers

Kazi
0

Can't connect MATLAB 2016 to Arduino using arduino() function ??

Asked by Kazi
on 28 May 2016
Latest activity Commented on by Walter Roberson
on 10 Mar 2019
Hi,
I am working on a servo motor that's gonna receive an angle value from matlab. Previously we were using arduino ide but there were problems in creating an arduino serial communication. Then we began using serial communication with arduino built-in function in matlab 2016.
But problem did not go away. Even a few minutes ago, the servo was doing the job. Then when we ran the program again, this popped up, again,
" Failed to open serial port COM5 to communicate with board Mega2560. Make sure there is no other MATLAB arduino object for this board. For troubleshooting, see Arduino Hardware Troubleshooting."
This has been really frasustrating ! Please guyz, anyone have any idea what went wrong here or how to solve it ??
Thanks in advance.
a=arduino();
s=servo(a,'D9');
angle=30/180;
writePosition(s,angle);

  0 Comments

Sign in to comment.

2 Answers

Answer by Walter Roberson
on 28 May 2016
 Accepted Answer

You have an existing arduino object. The single easiest way to make certain it is gone is to restart MATLAB.

  2 Comments

Thanks Walter, that worked. All I had to do was write these two in the beginning of the code
clear a
clear s
That's it !
I still can't get a connection, Is there any other solution ?

Sign in to comment.


Answer by HAMZA ABBASI on 24 Jun 2018
Edited by HAMZA ABBASI on 24 Jun 2018

write clear all in the first line of code

  3 Comments

it doesnt work even I cleared all before writing the code. it gets the same error:
>> a=arduino('COM41','Uno');
Failed to open serial port COM41 to communicate with board Uno. Make sure there is no other MATLAB arduino object for
this board. For troubleshooting, see Arduino Hardware Troubleshooting.

Sign in to comment.