Simulation stuck in the Termination phase in Simulink 2014b!!

Hi everyone, I am using Simulink 2014b for a project which admittedly has a lot of subsystems and takes the Ramp source as an input. I have to run the simulation for 10 s. The simulation is slow (takes around 20 min!) but the greatest problem arises when the simulation ends and gets stuck at the "Terminating" phase. If I try to stop the Simulation, the MATLAB hangs and I have to end it from the Task Manager (all the data is lost inevitably!). I don't get what the basic issue is as my system is pretty adequate (16GB RAM, Core i7, 1TB hard disk) and the simulation runs fine, albeit slowly, for step inputs! Any help would be greatly appreciated! Thanks.

[Annatha K R]

have you solved your problem? If yes please tell me how you did. I'm facing same issue as well.

[Francois Godin]

Yes, this happens to me too. In my case it is generally accompanied by a bunch of Java Exceptions:

Exception in thread "AWT-EventQueue-0" java.lang.OutOfMemoryError: unable to create new native thread
  at java.lang.Thread.start0(Native Method)
  at java.lang.Thread.start(Unknown Source)
  at java.util.concurrent.ThreadPoolExecutor.addWorker(Unknown Source)

It happens quite often, I'm curious if there is a way other than completely Killing MatLab.

Answer 1

[Dario Mangoni]

It's sad to see that the same problem is still there even eight years later...

Answer 2

[Prakash Patil]

I'm facing the same issue. Please let me know if anybody has solved their problem. Thank you!

Answer 3

[Gökhan Bayraktar]

Have you solved this problem? I am having almost same issue, please help me if you managed to solve. Thanks

Answer 4

[Souarv De]

I am also facing the same issue.

Answer 5

[xin li]

facing same problem.......

[xin li]

solved by change simulation mode to fast mode

Answer 6

[Jun Yang]

same situation here!

[remadel]

still on the same situation after 10 years