No ECU address replacements at post processing using ert.tlc system target file

I'm running code generation with my TI C28x(F28069) Board and M2014b.

When I'm using the idelink_ert.tlc System target file the Diagnostic Viewer tell's me that he found an ASAP2-File and replace These addresses.

I think the following Perl-script matlabroot\toolbox\target\extensions\processor\tic2000\asap2\asap2post.pl is running at the post process of code generation. But when I'm using ert.tlc system target file it did not run.

Could somebody explain why ECU addresses didn't replace automaticly?