FOR Loops for genearting multiple plots and using only one Column of Data from Each Table (Multiple Tables Present)

Hello,

I have a Cell Variable named Complete_Table. Which has multiple Tables within it (3 in the example shown in attached images). I would like to make plots using FOR Loop where in I can Only use the the Third Column of Each Table under Complete Table aganist a Static X-Axis with ("LG","MG","CG") as names No Data in General. In Simple Words the X-Axis doesn't change so that is not a Issue. In my Loop the Script I have added below I am not able to dynamically index for the Y-Data to Change from First Table (Var1_3) to Second Table (Var2_3) to Third_Table(Var3_3) and So on.

Also The Variable names here are seem same but are different. Like Var1_3 is associated with First Table and Var2_3 is associated with Second table.

for op = 1:length(Complete_table) % Helps us learn the number of tables present in the Cell.
    figure;% Produces the Same number of figurs as number of Tables or varable op.
    Y_Data = Complete_Data(op()); % here it When op =1 it is looking at the first table but not sure how to proceed for it to look at Var1_3 and so on & so forth.
    plot()
end

Any suggestion in the right direction would be great.

Thank you for your time and effort..

Answer 1

[Cris LaPierre]

You'll need to define what your X_Data is, but something like this should work.

for op = 1:length(Complete_table) % Helps us learn the number of tables present in the Cell.
    figure;% Produces the Same number of figurs as number of Tables or varable op.
    Y_Data = Complete_Data{op}.(3); % here it When op =1 it is looking at the first table but not sure how to proceed for it to look at Var1_3 and so on & so forth.
    plot(X_Data,Y_Data)
end

[Sai Gudlur]

Thank you This works Great. One More quick question.

If i have extract info from (1,2) First Row & Second Column of each table Could I Say.

ABC = Complete_Data{op}.1.(1,2);

[Cris LaPierre]

That syntax doesn't look correct to me, but you can always test it out in MATLAB.

I always refer to the Access Data in Tables page when I'm unsure.

I think you would want to use Complete_Data{op}.(1,2);

[Sai Gudlur]

Thanks Cris.