Cannot Add Parameters - "Parameter is not floating point and will be cast to double"
101 Ansichten (letzte 30 Tage)
Ältere Kommentare anzeigen
Dieter
am 21 Sep. 2024 um 17:01
Beantwortet: Dieter
am 24 Sep. 2024 um 18:30
I am trying to use the sensitivity analyzer on a golf swing model I have that uses parameters from model workspace. Whenever I try and add parameters to the sensitivity analyzer. Whenever I try and add it says:
"The following parameter(s) are not floating point and will be cast to double: HipConstant"
After saying this it does not add the parameter and does not cast it to double. How do I change my parameters to floating point if that is in fact the issue.
I've tried going into the model workspace and changing parameter data type from auto to double and it doesn't change the behavior.
Edit: I've attached the model and input file to the question.
4 Kommentare
Sreeram
am 24 Sep. 2024 um 8:28
@Maven Euler: I fixed it by clearing the PreLoadFcn, and placing ModelInputs.mat in the same folder as the SLX file.
Akzeptierte Antwort
Sreeram
am 24 Sep. 2024 um 8:28
Hi Dieter,
I also faced the same issue with the model you shared in MATLAB R2024a. However, I could successfully add the parameter in MATLAB R2024b. So, I recommend updating to MATLAB R2024b.
I hope it helps.
0 Kommentare
Weitere Antworten (1)
Siehe auch
Kategorien
Mehr zu Introduction to Installation and Licensing finden Sie in Help Center und File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!