I have trouble getting MATLAB to increase altitude or plot tail height upward when I use a positive number. I have to use a negative number. Why is this???

Code:
pn=0;
pe=0;
pd=0;
phi=0;
theta=0;
psi=0;
handle=[];
%Simulation parameters
dpn=0.5; %Change in position.
dpsi=0.01; %Change in yaw angle.
simlength=150;%Number of Sim Steps
%Draw and update the plane's position.
for k = 1:simlength
pn = pn+dpn;
pe = pe+dpn;
%THE CODE THAT PRODUCES A PROBLEM IS BELOW
pd = pd - 0.1;
There's also a problem with the tail fin. I have to designate it as being oriented "downward"...in the negative direction, to produce a vertical tail oriented upward. This is similar to the increment for the vertical height scale above, being increased with a negative number.

1 Kommentar

That is because a positive pitch always causes the tail of the plane to drop relative to the nose.

Melden Sie sich an, um zu kommentieren.

 Akzeptierte Antwort

Pat Gipper
Pat Gipper am 1 Jun. 2024
Bearbeitet: Pat Gipper am 1 Jun. 2024
The NED (North East Down) coordinate system is positive in the plane crashing direction. That's why it is good to use a negative dpd to avoid a descent. The Roll-Pitch-Yaw (phi theta psi) system is shown in the figure below, with credits to the citation shown. Positive change in the pitch angle (theta) have a standard change in the orientation of the plane to bring the nose up. Note that NED zero position is located at the nose of your aircraft as opposed to the typical center of gravity of an airplane that might be about mid-wing. As a result, when you pitch up then the entire aircraft will drop below the nose, very unusual.
E., J.R. (2016). Runway detection from map, video and aircraft navigational data. 10.13140/RG.2.2.26415.79525.

Weitere Antworten (0)

Produkte

Version

R2019b

Gefragt:

am 1 Jun. 2024

Kommentiert:

am 1 Jun. 2024

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by