how to run the motor Teknic 2310-P with the BOOSTXL-3PHGANINV and F28379D LaunchPad.

Hello, I need help to run the PMSM motor uisng Simulink.

The examle in the motor control bockset is not running my motor. can any one help me.

Answer 1

[akshatsood]

Hi @Aizaz Ali

I understand that you are interested in running the motor Tekni 2310-P with the BOOSTXL-3PHGANINV and F28379D LaunchPad. To achieve this, you can refer to the following MATLAB answers that discuss modifications in the Model file, enabling the motor to work with BOOSTXL-3PHGANINV inverter.

https://in.mathworks.com/matlabcentral/answers/1590809-motor-parameter-estimation-with-boostxl-3phganinv?s_tid=answers_rc1-2_p2_MLT

I hope this helps.

[Aizaz Ali]

@akshatsood Can you help me My email [e-mail]

[akshatsood]

Hi @Aizaz Ali,

Could you please state the the purpose behind writing through email. Did you follow the answer I have attached above? Kindly let me know if you require additional help regarding your query.

[Aizaz Ali]

@akshatsood Hello,I hope you are doing well i Actally want the detail what Keyur Mistry is refering too

The file 'mcb_param_est_f2839D_DRV8305.slx' does not support the BOOSTXL-3PHGANINV. Model file is required to be modified to make it work with the BOOSTXL-3PHGANINV.

To understand what modification is required, the difference in architectural design of BOOST-XL-DRV8305 and BOOSTXL-3PHGANINV need to be considered.

when i test the open loop file it works but when i try to run the PMSM motor in FCL it not working and in don't know what to do specifically.

[akshatsood]

Hi @Aizaz Ali,

Please refer to these helpful resources which might be of your help.

https://in.mathworks.com/help/mcb/gs/run-three-phase-AC-motors-open-loop-control-calibrate-adc-offset.html

https://in.mathworks.com/help/mcb/gs/quadrature-encoder-offset-calibration-pmsm-motor.html

https://in.mathworks.com/support/search.html/answers/594823-does-motor-control-blockset-supports-f28379d-control-card.html?fq%5B%5D=asset_type_name:answer&fq%5B%5D=category:mcb/getting-started-with-mcb&page=1

Do let me know if you are still caught up with the issue.