"I'm trying to add an 'if' statement to analyze each result, but Matlab is 'ignoring' the condition and not performing the addition."
1 Ansicht (letzte 30 Tage)
Ältere Kommentare anzeigen
"I'm trying to add an 'if' statement to analyze each result, but Matlab is 'ignoring' the condition and not performing the addition."
I need that when some value of c (not all) is less than 0, d becomes rad2deg(theta) + 180, when any of the values of c is greater than or equal to 0, d becomes rad2deg(theta)
"The values of c are attached."
I think I'm not managing to explain my problem, I'll try again:
theta = acos(UV ./ Uv);
c = Y(:,2); where Y(:,2) is generated by ode45, meaning there are several values (a total of 547).
I need to check the values of "c." When the value of "c" is < 0, the value of "d" is d = rad2deg(theta) + 180; when not, d = rad2deg(theta).
So, for each value analyzed in "c," a value of "d" is calculated (if <0, d = rad2deg(theta) + 180; if not, d = rad2deg(theta)), meaning, in the end, I will have 547 values of "d" based on the rules above.
Thank you very much for your attention.
[T,Y] = ode45(@myprog,tSpan,s,options);
.
.
.
c = Y(:,2);
if c < 0
d = rad2deg(theta) + 180;
else
d = rad2deg(tetha);
end
2 Kommentare
Walter Roberson
am 19 Okt. 2023
Is theta a scalar or a vector? Is it calculated from c? Is it possibly the same as c ?
Antworten (2)
the cyclist
am 19 Okt. 2023
Is c a vector? If so, then all elements of c would have to be less than zero, to enter the if condition. This is explained in the documentation.
2 Kommentare
Walter Roberson
am 19 Okt. 2023
The second output of ode45 is guaranteed to have at least three rows (unless there are perhaps some strange combinations of circumstances.) Just maybe if there was an event function that always signalled termination you might be able to get it down to two rows.
Torsten
am 19 Okt. 2023
Verschoben: Torsten
am 19 Okt. 2023
c is a vector. Do you want d to be rad2deg(theta) + 180 if all elements of the vector c are < 0 ? Then your code is correct. Otherwise you have to loop over the elements of c:
for i = 1:size(c,1)
if c(i) < 0
...
else
...
end
end
Siehe auch
Kategorien
Mehr zu Creating and Concatenating Matrices finden Sie in Help Center und File Exchange
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!