Hello,
I am using a Matlab code in order to simulate a Simulink power system. To specify, the code runs the first data (each data originates from a table and represents a neighboorhood's load needs), simulates, loops back, refreshes the data (new row in table), simulates, and so on.
There are also some variables that sum up the load needs from the data, and some variables that sum up the power system's actual generation. For example the first will show that a load of 100 kW is requested. The actual generation might be 100,3 kW.
When I run the system straight from Simulink, it runs perfectly. The results are optimal, as well as the scopes.
When I run the system through Matlab though, some vast differences come into play. The variables are way off, for example the total load requested is 100.000 kW, but the actual generation is 100.000.000 kW. The scopes are somewhat closer, but I believe that they can be fixed with Operating Set Points.
Any ideas on how to fix my problem? Essentially it's the same system, but the results are different.
