There is a bug in the realtime udp receiver block. Below a certain amount of bytes, the block will not receive any byte. Actually I am testing a patch of MathWorks. In a short time the patch will be available on MathWork's support page.
xpc realtime udp receive
2 Ansichten (letzte 30 Tage)
Ältere Kommentare anzeigen
Does anybody have a short example how to use an xpc realtime udp receiver block? I am able to write out an udp packet to a "sensor" which will answer after receiving the packet. To check the answer, I am using wireshark. But I am not able to receive this packet with the xpc target.
It seems to me, that the xpc realtime receiver block is misconfigured or has a bug, may be the packet size is too short?
Was anybody able to use this receiver block successfully?
0 Kommentare
Antworten (4)
Mirko Kunze
am 22 Mär. 2012
Any updates on this issue? I have the same problems and did not find any patches.
0 Kommentare
Peter Wehrli
am 22 Mär. 2012
2 Kommentare
Celine Chia
am 11 Jun. 2012
Erm,
how do you do you find the bug report 783622? do you have the link?
I googled it and nothing.
Walter Roberson
am 11 Jun. 2012
Bug reports can generally be found at http://www.mathworks.com/support/bugreports/
That particular one is either not present or not publicly visible.
Rajiv Ghosh-Roy
am 11 Jun. 2012
I think you need to set the "release exists in" to R2011b.
0 Kommentare
Siehe auch
Kategorien
Mehr zu Target Computer Setup finden Sie in Help Center und File Exchange
Produkte
Community Treasure Hunt
Find the treasures in MATLAB Central and discover how the community can help you!
Start Hunting!