How to get ESP32 as an option for board when setting up hardware setup

Hi i am follow this link to connect ESP32 to matlab

https://au.mathworks.com/help/supportpkg/arduinoio/ug/configure-setup-for-esp32-hardware.html (MATLAB Support Package for Arduino Hardware)

However when I follow instructions i do not get the options of ESP32. How do i make it so that i can?

Answer 1

[Jongil Lee]

Hi Jordan

Please check your MATLAB/Simulink version using "ver" command.

ESP32 board supports from MATLAB R22a. Please refer to check link.

[Jordan Hill]

Hi Jongil,

Thank you so much. I was running a 2021 version so it wasnt working. However we have a ESP32-S3-WROOM-2, is there anyway that board is supported or can we not connect to that one?

Kind regards,

Jordan

[Mike]

I have the same Question. Can i change the config to suport ESP32-S3?

[Alex Winkler]

Same here... ESP32-S3 wroom-2 devkit C1.