I am getting an error 'Output Port 1' of 'Wind_Turb​ine/Scopes​/Blade Load Scopes i not connected." when i run the model below but I'm not sure where to connect the in/output

I am getting an error 'Output Port 1' of 'Wind_Turbine/Scopes/Blade Load Scopes i not connected." when i run the model below but I'm not sure where to connect the in/output ?

Answer 1

[Dimitri MANKOV]

Hi Karam,

It looks like these output ports are not used anywhere in your model, so you can simply delete them to get rid of the warning message.

I hope this is helpful!

Dimitri