How to connect Raspberry Pi to DAC MCP 4921 using SPI Simulink blocks?

5 Ansichten (letzte 30 Tage)
Ben Depoorter
Ben Depoorter am 30 Jan. 2023
Kommentiert: Sylvain am 16 Feb. 2023
I want to set an output voltage with a RaspberryPi with an DAC MCP4921 using Simulink, in particular using the new block "SPI Register Write" available in the latest Simulink version (without writing C code or Matlab code). In this block is required a Register Address where SPI has to write the value from the slave. Can anyone help me?
  1 Kommentar
Sylvain
Sylvain am 16 Feb. 2023
Looking at the datasheet, the write command register is not defined.
Can you try the "SPI Master Transfer" block with a terminator for the output?
You should send the a vector of [2x1] uint8 for the upper half and the lower half.

Melden Sie sich an, um zu kommentieren.

Antworten (1)

Mark McBroom
Mark McBroom am 5 Feb. 2023
Would you want to use the SPI Read/Write/Master blocks to communicate with this external device, similar to this example that uses SPI to communicate with an external EEPROM device?
https://www.mathworks.com/help/supportpkg/raspberrypi/ref/communicating-with-an-eeprom.html

Community Treasure Hunt

Find the treasures in MATLAB Central and discover how the community can help you!

Start Hunting!

Translated by